Installation • Slider and Hung

1. Seal all around the opening.

2. Insert window in the opening.

3 Put shims underneath each post, both sides and make sure that the window frame is straight, square and level all around.

4. Screw every anchor plate to install and adjust the window properly.

5. Make sure that the sides are straight and screw solidly the anchors.

6. Seal all around between the brick mould and the trim.

N.B.  The warranty will be cancelled if the instructions listed above are not followed properly.

Tilt Wash Instructions

Before tilting in, the lower sash must be raised at least 6 inches. If these instructions are not followed, damages could occur and will not be covered by Fenêtres Unique Windows Inc. warranty.

© Unique Windows - All rights reserved 2018  XHTML valid CSS valid
Website created by: Productions Rouj and Concept J MULTIMEDIA Inc.